Zip GP-SUPA004, Instruction Manual

Page: 207 / 381

© 2023 System Q Ltd
201
Index
ZipDVR.com
1. Set the Rule Kind drop down list to Rect .
2. Set the Detection Area drop down list to Customise .
3. Click on the camera's image where you want to set the top left corner of the
detection area.
4. Click where you want to set the bottom left corner.
5. Click where you want to set the bottom right corner.
6. Finally click where you want to set the top right corner of the detection area.
You will notice as you are setting your corner points the recorder will draw a red box
between between the points.
Face Detection When Crossing A Line
You can set up face detection to only trigger when somebody crosses over a line to
better control when faces are captured. You can even set which direction the line is
crossed before a capture so you can monitor for face on entry or as people exit. To
set up line crossing face detection follow these simple steps:
1. Set the Rule Kind drop down list to Line .
2. Click on the camera's image where you want to start the line crossing.
3. Click where you want to stop the line crossing.
4. Finally select which direction a person crosses the line before face detection is
triggered from the Rule Type drop down list, from side A to B ( A->B ) or from side
B to A ( B->A ).
You will notice as you are setting your points the recorder will draw a yellow line
between them.
Editing A Detection Area
You can edit the existing detection area by simply dragging any of the red corner
squares to where they are required.
Determining When Thumbnail Snapshots Are Captured
You can determine how the recorder will capture thumbnail snapshots when a face is
detected using the
Snap Mode drop down list.
Default: Will only capture a snapshot when the face are first detected. Additional
thumbnail snapshots will only be captured if the person leaves the camera's image
and returns.
Realtime: Will only capture a snapshot from just before the face leaves the image.
Interval Mode: Will allow you to specify how many and how often thumbnail
snapshots are captured using the Snap Num and Snap Frequency fields.