Zero 88 FLX Series, Manual

Page: 143 / 233

The Faders window will show you information about programmed
channel data UDKs. It will display the UDK number, the fact it is a
Channel Data UDK, and then a row of settings information.
Naming Channel Data UDKs
UDK’s which have been recorded can be named by pressing Name and then pressing the UDK button. An
onscreen keyboard will appear for you to type in the required name. Press Enter to complete.
The name will then be displayed in the onscreen UDKs in the Faders window.
Updating Channel Data UDKs
If you need to make a change to a UDK you can update it. As with updating cues, it is a good idea to output your UDK,
make your changes, and then save the update. You may therefore wish to configure the UDK button to be latch rather
than flash, if it isn't already.
See the UDK Settings section for more information.
Once set to latch, tap the UDK so that it is active and outputting, make your changes, tap Update , and then tap your
UDK. Your manual values will be merged with the UDK.
Deleting Channel Data UDKs
To delete a UDK, tap Delete , and then tap the flashing button of the UDK you wish to Delete. You can then confirm
by clicking Yes . Tapping the button of an unprogrammed UDK will display a message stating the UDK is not
programmed.
For example:
Delete UDK1 Enter
Delete UDK <1>,
This deletes UDK 1.
UDK Settings
Once you have programmed a channel data UDK, you can configure
it. To do this, hold Setup and tap the UDK you wish to configure, to
open the UDK Settings.
After making changes in the UDK Settings, click OK to save, or Cancel
to discard.
Zero 88 - ZerOS - Page 143 of 233 Printed: 23/11/2020 12:50:03 JH