212
Maintenance / Further information
G-30-1530-en
OPMI® VISU 210 on S8, S81, S88 Suspension Systems
Issue 1.0
Printed on 19. 04. 2004
Changing the halogen lamp
Warning!
If you change the lamp shortly after it has failed, the lamp will still be very
hot. Wear heat-protection gloves to avoid burns!
Note:
If both halogen lamps (4 and 5) fail during surgery, insert an available
backup lamp module. Therefore, always make sure before surgery that
the halogen lamp in the backup lamp module is intact.
To change the lamp, proceed as follows:
•
Switch off the illumination system via knob (3) and the unit at its power
switch.
•
Press button (2), the lamp module is slightly ejected. Pull out the lamp
module (1).
•
Remove the defective halogen lamp from the spring-loaded mount.
•
Pull ceramic base (8) from the contact pins of the halogen lamp.
MISU241
