OPERATION
Carl Zeiss
Operating the motorized microscope via the touchscreen of the TFT display
Axio Imager
116
430000-7344-001
M70-2-0020 e 06/2009
4.8.5.4
XYZ page
The
Microscope/XYZ
page contains two tabs:
Position
and
Measure
.
The availability of the
XYZ
page
depends on the microscope stage
used:
−
Motorized stages (only CAN bus
stages that are directly connected
to stands .M2 / .M2p / .M2m or
.Z2 / .Z2m:
Allows settings of XY coordinates
and Z focusing drive
−
Manual stage:
Allows settings for Z focusing drive
only (all XY controls are absent),
Measure
tab not accessible
−
Manual stage/manual Z focus
drive:
XYZ
page is not accessible
During microscope initialization, the
system detects whether a stage is
installed.
Therefore, the stage must be changed
only with the microscope switched off.
(1)
Position tab
The control area under the
Position
tab is
subdivided into three functional blocks.
If you do not use a motorized stage,
the
Start
button is available in place
of the XY controls (refer to (2)
Measure) below.
Current position display / Set Zero
Displays the current positions of Z, X and Y in
millimeters (mm).
If no motorized Z focusing drive is
installed, the Z position is not
accessible.
Fig. 4-50
Mikroscope -> XYZ
Fig. 4-51
Microscope -> XYZ -> Position
