Zanotti un0 010, Workshop Manual

Page: 204 / 248

7-193
7.1 Parameters - Single
temperature version
Annex 1
Sensors Configuration Parameter Table
Label Description Udm Value
P2P Environmental probe presence - OFF
P3P Evaporator air delivery probe presence - OFF
Csa Cold room probe calibration °C °F 0 0
CF Measure unit selection
°C °F
C F
Digital Input Management Table
Another column, present in cab command menu, indicates actual sensor state (ON/OFF) read by CPU board.
Label (Sensor) Logic Abilitation J8 Input Pin
High Pressure Switch Op En 13
Low Pressure Switch Op En 2
Clixon cl En 14
Differential pressure switch cl En 1
Oil Pressure cl En 9
Electric Standby Selected cl En 7
Water Temp cl En 8
Set-Point Comm. cl Dis 5
Thermal Overload protection cl En 12
Door Open cl Dis 6
Door Microswitch cl En 15
Defrost Input cl Dis 4
Remote ON/OFF Op En 10
Digital Output Management Table
Another column, present in cab command menu, indicates actual device state (ON/OFF) managed by CPU.
Label (Device) Mode Set State J9 Output Pin
Alarms Aut 2
Heating Aut 4
Evaporator Fans Aut 5
High Speed Aut 6
Electrical Motor Aut 7
Partialization Aut 8
Starter Aut 10
Fuel Pump Aut 12
Pre-heating Aut 13
Alternator Aut 14
Anti-Freeze Man OFF 9
Condenser Fans Aut 15
Clutch Man OFF 3