YATO YT-828293, Manual

Page: 15 / 172

15
O R I G I N A L I N S T R U C T I O N S
EN
TOOL DESCRIPTION
The angle grinder is a power tool designed for grinding and cutting metals and mineral building materials such as brick, natural
and arti fi cial stone, concrete, glazing, etc. using abrasive discs and grinding wheels selected for a given material. Under no
circumstances must the tool be used for processing materials other than those mentioned above, e.g. for grinding and cutting
wood or polishing. The correct, reliable and safe operation of the grinder requires its proper use, so before using the grinder:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
Always use an eye guard!
Do not use grinding discs with a maximum permissible perimeter speed of less than 80 m/s!
Do not use grinding wheels with a maximum permissible rotational speed lower than the grinder’s speed.
The supplier is not liable for any damage resulting from failure to observe the safety instructions and recommendations contained
in this manual.
EQUIPMENT
The tool is delivered complete but requires preparation before starting work. The product is supplied with a battery pack, a
charging station (charger), an abrasive disc guard, a wrench for fi xing the grinding disc and an additional handle. The equipment
does not include abrasive discs. The YT-828293 product does not have a battery pack and a charging station.
TECHNICAL DATA
Parameter Unit Value
Part no. YT-828293, YT-828294, YT-828295
Mains voltage [V] 18 DC
Rated rpm [min
-1
] 3000 – 8500
Diameter of the abrasive disc [mm] 125
Diameter of the abrasive disc hole [mm] 22.2
Spindle taper M14
Weight [kg] 1.26
Noise level
- sound pressure L
pA
± K
pA
[dB (A)] 89.0 ± 3.0
- power L
wA
± K
wA
[dB (A)] 97.0 ± 3.0
Vibration level
ah,AG
± K (main/additional handle) [m/s
2
] 7.28 ± 1.5
Insulation class III
Protection rating IPX0
Battery type Li-Ion
Battery capacity [Ah] 4
Charger*
Input voltage
[V] 220 – 240
Mains frequency [Hz] 50/60
Output voltage [V] 21 DC
Output current [A] 2.4
Rated power [W] 60
Charging time** [h] 2
* only for models equipped with a battery and charger
** the speci
fi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may di ff er from the declared value, depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use
(including all parts of the work cycle, such as the time when the tool is switched o ff or idle and the activation time), must be speci fi ed.