YASKAWA Motoman MLX200, Hardware Installation & Software Upgrade

Page: 89 / 121

11 Teach Pendant Software Upgrade Procedure (Fuji Pendant)
11.1 Configure PC to use a Static IP
11-3
168283-1CD
168283-1CD
Hardware Installation &
Software Upgrade
11.1.1 Prepare Pendant to Set the IP Address for the NEW/
UN-PROGRAMMED System
After power up, if the screen below is displayed, this is an un-programmed
pendant if this screen does not appear complete
section 11.1.2 “Prepare
Pendant to Change IP Address for an Upgraded System”
1. Press [IP ADDRESS] button on screen.
2. Press [EDIT] on the new screen.
3. Proceed to
section 11.1.3 “Setting IP Address for Pendant”
11.1.2 Prepare Pendant to Change IP Address for an Upgraded System
Ensure the screen in
section 11.1.1 “Prepare Pendant to Set the IP
Address for the NEW/ UN-PROGRAMMED System”
is not present before
performing the following steps. If the screen is present perform
section
11.1.1 “Prepare Pendant to Set the IP Address for the NEW/ UN-
PROGRAMMED System”
instead of the following steps.
1. Press the SYSTEM key on the pendant (purple, right side).
2. Press the F1 key (this should say MODE on the screen).
3. Press [Main Menu] on the touch screen.
4. Press [Ethernet] on the touch screen.
5. Press [Edit} on the next screen.
6. Proceed to
section 11.1.3 “Setting IP Address for Pendant”
89 of 121