YASKAWA GA800 Series, Programming Manual, Page: 555 / 644

Keypad
Use
and
T
est
Run
3
3.4 Keypad Operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 555
•
When there are a minimum of two screens, push or to switch between screens.
•
If you registered only one custom monitor to [Custom Monitor 1], the screen will show only one monitor. If you
registered custom monitors only to [Custom Monitor 1] and [Custom Monitor 2], the screen will show only two
monitors.
◆
Set the Monitors to Show as a Bar Graph
The procedure in this section shows how to show the frequency reference monitor as a bar graph.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2.
Push (Menu).
3.
Push or to select [Monitors], then push .
4.
Push or to select [Bar Graph], then push (Setup).
5.
Push or to select the location to store the monitor, then push .