Yamaha TT-R125(S) 2003, Owner'S Service Manual

Page: 154 / 610

2 - 28
SPEC
1 Air vent hose
2 Spark plug lead
3 Starter cable
4 Throttle cable
5 Clutch cable
6 Clamp
7 Cable guide
8 Engine oil breather hose
9 Overflow hose
Å
After clamping the starter cable, push it against the starter plunger.
ı
Put the tip of the air vent hose into the main pipe.
Ç
Install the primary coil terminal (orange) to the ignition coil.
Î
Fasten the ground lead together with the ignition coil.
‰
Pass the starter cable so that it is not twisted.
Ï
Tighten the starter choke nut while taking care not to twist the starter cable.
Ì
Pass the clutch cable on the inside of the throttle and starter cable.
Ó
Clamp the clutch cable with the paint in the cable guide bottom recess.
È
Pass the throttle cable and starter cable into the cable guide.
Ô
Pass the engine oil breather hose and overflow hose between the right
half of the swingarm and pillar tube.

Clamp the engine oil breather hose, overflow hose and air vent hose to 2 clicks.
CABLE ROUTING DIAGRAM