206
Chapter 10—Front Panel Operation
DME32—Owner’s Manual
Temporarily Disabling the Protection System
The protection system can be temporarily disabled to allow editing by authorized users.
1
Press the [PROTECT] button.
The Enter password display appears, as shown below.
2
Use the SCENE RECALL number keypad to enter the password.
An asterisk appears as each number is entered, as shown below.
3
Press the [RECALL] button.
If the correct password is entered, the protection is disabled and the PROTECT indica-
tor goes out. If the password is incorrect, the Change password display appears. Press
the [VALUE] button to cancel this display.
While the protection system is temporarily disabled, scenes can be stored and recalled
and parameters can be edited as normal.
4
To turn the protection system back on again, press the [PROTECT] button.
The Shift to Protect Mode display appears, as shown below.
5
Press the [VALUE] button to enable Full Protect mode, or press the [PARAM-
ETER] button to cancel.
Full Protect mode is enabled and the PROTECT indicator lights up.
If you forget the password, see “Checking the Firmware Version & Battery” on page 210.
SCENE NO.
CONFIGURATION
SCENE
XXXX
password
X
=
Enter
X
password
0 i
SCENE NO.
CONFIGURATION
SCENE
XXXX
password
X
=
X
****
Enter
X
Password
0 i
SCENE NO.
CONFIGURATION
SCENE
XXXXXXXXXX
No
XXXXXXX
Yes
Shift
X
to
X
Protect
X
Mode?
0 i
