RS-1600/1602-FC-SBD User Guide
36
2.9
Drive Carrier Configuration
2.9.1 Planning and Configuring Your Installation
2.9.1.1
System Configuration
Important
Before you begin installation you should become familiar with the configuration requirements of
your RS-1600-FC-SBD or RS-1602-FC-SBD subsystem. Please refer to Section
2.2
for information
on your overall system configurations.
There must be a drive present in Bay 1/1 or 4/4 to enable SES Communications to operate.
Installing drives in both of these bays will provide redundant SES communication paths.
When planning your system configuration, please remember that:
• All RS-1600-FC-SBD and RS-1602-FC-SBD enclosure
drive bays must be filled with either a drive
carrier or front dummy fascia, no bays should be left completely empty.
2.9.1.2
Drive Configuration
Important
After you have installed the drive carrier modules in your RS-1600-FC-SBD or RS-1602-FC-SBD
enclosure, please refer to Section
2.6
for configuration information relevant to the SBD module
you are installing.
2.10 Drive Carrier Installation
2.10.1 Parts Check List
• Drive Carrier module, or
• Dummy Carrier module
2.10.2 Procedure
1
Release the carrier handle, by pressing the latch in the handle towards the right and insert the carrier into
the enclosure.
Important
For a Rack Mounted System: Ensure that the carrier is orientated so that the drive is uppermost
and the handle opens from the left (
Figure 2–16
).
For a Tower System: Ensure that the carrier is orientated so that the carrier lock position is
uppermost and the handle opens from the top (
Figure 2–17
).
Summary of Contents for RS-1600-FC-SBD
