Chapter 3 – Installation
3-7
•
Rear drive bay cover plate
•
Floppy drive access door and mounting hardware for use in panel mounting installa-
tions.
To install the floppy drive on the front of the computer module,
1.
Disconnect all power supplies from both the monitor and computer modules.
2.
If the computer module is mounted to the monitor module, remove the computer
module, as described in
Removing the Computer Module
, later in this chapter.
3.
Remove the five screws that secure the top cover to the case, and open the case.
4.
Use a screwdriver to pry out the knockout panel in front of the drive bay. Remove
and discard the knockout panel.
Caution
To avoid injury, be sure to completely remove the knockout tabs from the module
chassis and dress the opening with a file to completely remove any burrs. Take care to
ensure that metal filings do not contaminate the interior of the 9457 case.
5.
Locate the floppy drive, at the rear of the case, then disconnect its power and data
cables.
6.
Remove the two screws on the module’s rear wall that hold the drive bracket to the
chassis, then slide the drive and bracket forward and up to remove it from the mod-
ule.
7.
Remove the four screws that hold the drive to the mounting bracket. Set the bracket
aside.
8.
Remove the four screws that hold the front drive mounting plate to the front drive
mounting bracket, and remove the front drive mounting plate from the case.
9.
Mount the floppy drive to the front drive mounting plate by installing the four screws
you removed from the drive mounting bracket in Step 7 through the front drive
mounting plate into the mounting holes on the bottom of the floppy drive.
