9457 Industrial Computer
3-4
Preparing the System for Use
To prepare the system for use, perform the steps listed below. If you purchased any op-
tions, install them according to the instructions in the next two sections.
1.
Make certain that the power switch on the computer module is turned OFF.
2.
Connect the video cable between the 15-pin Video In connector on the back of the
monitor module and the video connector on the processor card in the computer mod-
ule.
3.
Connect the Host/LED 15-pin cable between the Host/LED ports on the monitor
module and the computer module.
4.
Attach any other optional equipment following the instructions in
Installing External
Options
, later in this chapter.
5.
Attach the monitor power cord from the monitor to the power receptacle on the back
of the computer module.
6.
Attach the power cord from the power receptacle on the computer module to a prop-
erly grounded 115/230 VAC, 50/60 Hz outlet.
7.
Turn on power to the 9457 by pressing in the On/Off switch on the back of the com-
puter module.
8.
Set the contrast and brightness controls on the back panel to the desired levels.
9.
Install application software via drive A: located behind the access door on the front
panel.
Installing Internal Hardware Options
Caution
The computer module
must be turned off
before installing internal hardware.
Internal hardware options may be installed through the top cover of the computer mod-
ule. If the computer module is mounted to the monitor module, the computer module
must be removed from the monitor module, as described in
Removing the Computer
Module
, later in this chapter.
Installation and Removal of the CPU Board
This section describes the steps required to install and remove the CPU board. Some
CPU boards may require additional steps, or specific configuration parameters. Consult
the manual that accompanied your CPU board to determine whether such additional steps
are necessary.
