Chapter 3 – Installation
3-9
Figure Chapter 3 -5. Mounting the Front Floppy Drive Access Door to the 9457-RFC Rack Filler with Cut-
out
Installing a Device in the 5.25" Drive Bay
Caution
Use of controls adjustments or the performance of procedures other than those speci-
fied herein may result in hazardous radiation exposure.
The 5.25" drive bay located on the rear of the computer module may be used to hold an
externally-accessible 5.25" mass storage device. A CD-ROM drive will occupy this bay
if purchased as an option on this system.
To install a device in this bay,
1.
Disconnect all power supplies from both the monitor and computer modules.
2.
If the computer module is mounted to the monitor module, remove the computer
module, as described in
Removing the Computer Module
, later in this chapter.
3.
Remove the screws from the top cover and open the case.
4.
Remove the three screws that hold in the 5.25" drive mounting plate. Two are lo-
cated immediately below the 5.25" drive bay on the rear of the module, and the other
is on the side.
