ADSL2+ Tester 3 Manipulation
72-0046-03A 18
Warning:
Do not change the battery model!
Do not use old and new rechargeable batteries together!
Do not use non-recharge battery, in case that may cause the battery
explosion or other danger.
Caution:
When the battery supplied for this tester has been used expiring the charging
life or are impaired, they should be dealt with control. If dealt with general
waste processing system detained in the tester, they will harm the tester. The
waste batteries contain Nickel-Metal Hydride and must be recycled or
disposed of properly at special recycling station or hazardous waste collection
center.
n
Replacement of Rechargeable Battery
A new rechargeable battery can be charged and discharged for about 800~1000 times
before it can not be used any more. Normally the fully charged batteries could support the
tester continuous 2.5 hours working depending upon the test settings. So when the
operating duration of the battery is apparently reduced, the batteries should be replaced.
It is strong recommended that the rechargeable batteries should be replaced
every one or two years!
The NiHM recharge battery may become invalid after no used for a long time.
It can only be reused after reactivation.
n
Method of Battery Replacement
Ensure the tester is switched off firstly. And open the end cover of the tester and slightly
press the battery compartment lock card downward, the battery case will pop out. Extract
the battery compartment and unscrew the screws on the top of the case to open and replace
new batteries (Be careful of not mistaking the polarity of the battery). When the battery
compartment has been loaded again, slip it back into the battery case frame and push the
battery compartment inside (Put your fingers upon the case rather than the battery case
lock card), the battery case is installed well while a
“
KaTa
”
sound is heard. The battery
replacement is completed when the end cover of the tester is mounted again.
Warning
：
When installing the battery compartment back to the battery case frame,
please ensure not to push overexerted, which if not will result in impairing the
battery case frame or making the battery shrapnel damaged!
