Xiaguang XP XG2045, Manual

Page: 15 / 71

ADSL2+ Tester 3 Manipulation
72-0046-03A 15
3.3 Preparations for Operation
n
After unpacking, check if the carton or the appearance of the tester is damaged or
not.
n
Check if the tester and its accessories are integrated or not.
n
Plug the AC adapter into an appropriate AC wall outlet. And connect the tester with
AC power adapter cable, check if the
“ Charge ” status LED will be lit.
n
Press “ Power ” key to switch on the tester, LCD screen will display the LOGO of
manufacturer and the embedded software version. After 3 seconds, buzzer will beep
once, the software will be loaded completely and the tester is initializing for about 20
seconds.
n Select the function what you want to test, and link the test cable between the tester
and the line under test.
After making above steps, you can configure settings and make the
measurements.
3.4 Brief Menu Introduction
The operating menus of ADSL2+ Tester include “ Settings ” , “ Results ” , “ Storages ” and
“ Others ” menu, matched with the “ Setting ” , “ Result ” , “ Storage ” and “ Other ” functional
keys respectively. These four menus can be switched from one to another at any time by
pressing these four functional keys.
“ PgUp ” and “ PgDn ” keys provide page up and down functions, “ Cursor Moveable Right
and Down ” and “ Cursor Moveable left and Up ” keys provide cursor movement functions,
“ F1 ” , “ F2 ” , “ F3 ” , “ F4 ” softkeys are used to select the parameter or actions at the bottom of
LCD which matched with the place highlighted by the cursor.
In each of display areas the field currently able to be changed is marked by a “ Highlight
Cursor ” . The menu of selection available for the active field is displayed on softkeys on the
bottom of the display. The choice from the menu is made using the keys situated
immediately below the display. The highlighted cursor is moved around the display using
page and cursor keys. When a highlighted field has more than 5 choices a softkey labeled
>>
is provided. When
>>
is chosen the remainder of the menu is revealed.
n
“ Settings ” Menu
Press the “ Setting ” key to enter into the settings menu. All the information that related to
the chosen test function and the setting of the parameters are provided in the “ Settings ”
menu. Press the “ Cursor Moveable Right and Down ” and “ Cursor Moveable left and
Up ” keys to move the cursor, press the “ F1 ” , “ F2 ” , “ F3 ” and “ F4 ” softkeys to select the
corresponding parameters. In case page number appears in the LCD menu, such as “ P: 1/2 ” ,
turn page by pressing the “ PgUp ” or “ PgDn ” key. Press the “ Start/Stop ” key to start the