ADSL2+ Tester 4 Navigating the Displays
72-0046-03A 30
“
PING
”
testing includes
LAN PING
and
WAN PING
. In these two testing modes,
corresponding parameters should be set as described below in detail.
4.2.4
“
LAN PING
”
settings menu
After selecting
“
PING
”
test function, set the PING type as
“
LAN PING
”
. There are two
setting pages in this mode, as shown in Fig 8.
a.
Page 1 of
“
LAN PING
”
settings menu
In Fig 8, press
“
Cursor Moveable Right and Down
”
key to move the cursor to the
positions of
“
DST IP
”
,
“
LAN IP
”
and
“
IP MASK
”
, and then you can use
“
F1
”
,
“
F2
”
,
“
F3
”
and
“
F4
”
keys to choose the parameters.
All the setting parameters of above items are shown in Table 6.
Item
Range of IP Address
Option
DST IP
Destination IP address:
000.000.000.000~255.255.255.255
EDIT
RECENT
LAN (WAN) IP
LAN (WAN) IP address:
000.000.000.000~255.255.255.255
EDIT
RECENT
IP MASK
Subnet Mask:
000.000.000.000~255.255.255.255
EDIT
RECENT
Table 6: Setting parameters in Page 1 of
“
LAN PING
”
You can edit address by selecting
EDIT
to input a new IP address or
REC ENT
to input
the last 6 recent used IP address.
Caution:
You should ask the administrator for the detailed information about the
destination IP address, LAN or WAN IP address and subnet mask.
b.
Page 2 of
“
LAN PING
”
settings menu
Press
“
PgDn
”
key to go to Page 2, as shown in Fig 9. In Page 2, press
“
Cursor Movable
Right and Down
”
key to move the cursor to the position of
“
Writing Config
”
. And then
you can use
“
F1
”
to choose
YES
. And then all the setting configurations will be written
into the tester and become effective.
Any change of setting to the parameters of
“
DST IP
”
,
“
LAN IP
”
and
“
IP
MASK
”
should be re-configured by set
“
WRITING CONFIG
”
as
YES
. Only
after writing the configurations into the tester firstly can make the new
settings effective. If the IP address input is available,
“
write success
”
will be
displayed on the LCD. If the IP address input is invalid,
“
write fail
”
will be
displayed on the LCD.
Any change to
“
Packet Length
”
does not need reconfiguration.
