Xerox XNIC-E'NET, Configuration Manual

Page: 78 / 244

B a s i c X N I C C o m m a n d s
3-56
❖
X N I C - E ’ N E T / T ’ R I N G C o n f i g u r a t i o n G u i d e
Change the frame type. define server netware frame_type
(where Ethernet
frame_type
is one of the following:
• default — IPX will try 802.2, Ethernet II, 802.3, and
802.2 snap in order. The first one found will be
selected.
• 802.2 — IPX will only look for Ethernet 802.2 frames.
• snap — IPX will only look for Ethernet snap frames.
• 802.3 — IPX will only look for Ethernet 802.3 frames.
• ethernet_II — IPX will only look for Ethernet II frames.
(where Token Ring
frame_type
is one of the following:
• default — IPX will try 802.2 and snap in order. The first
one found will be selected.
• 802.2 — IPX will only look for Token Ring 802.2
frames.
• snap — IPX will only look for Token Ring snap frames)
This command sets the frame type for the XNIC. The default is
default .
Reset the XNIC remotely (soft reset). init delay 0
Reset the XNIC to factory defaults. init delay 0 default
Display network configuration parameters.
show server netware
Display NDS tree and context settings on
the XNIC.
list server netware
Disable PSERVER.
define server netware pserver disabled
Enable PSERVER.
define server netware pserver enabled
Disable RPRINTER.
define server netware rprinter disabled
Enable RPRINTER. define server netware rprinter enabled
Define the PServer that will attach to the
XNIC RPrinter.
define node pserver_name npserver
(where: pserver_name — Is the name of the PServer that will
remotely attach to the XNIC)
More than one npserver node may be defined.
Table 3.2 XNIC Tasks and Commands (continued)
Task Command
ETR-CH03 Page 56 Wednesday, October 23, 1996 6:46 PM