U s i n g t h e P r i n t e r w i t h L A T o n X N I C - E N E T O n l y
C h a p t e r 6 : U s i n g t h e P r i n t e r w i t h L A T o n X N I C - E N E T O n l y
❖
6-5
Setting
Optional
Configurations
This section describes optional procedures for communicating
with the XNIC-ENET to monitor system parameters or to
change the parameters from their factory defaults.
Logging into the
XNIC-ENET
To monitor or change configuration parameters on the
XNIC-ENET, you must first log into the XNIC-ENET from
your host.
Use the following procedure to log into the XNIC-ENET from
your host:
1
Run the NCP utility on the VAX by entering:
r u n s y s $ s y s t e m : N C P
(or
m c r
n c p )
2
Connect to the XNIC-ENET RCF port by entering:
c o n n e c t v i a
qna-0
p h y s i c a d d r
nn-nn-nn-nn-nn-nn
where
qna-0
is your actual circuit type, and
nn-nn-nn-nn-nn-nn
is the XNIC-ENETs Ethernet hardware
address.
3
At the
#
prompt, enter the password.
The default is
a c c e s s
. You will not see what you enter.
4
Enter your user name if the following prompt is displayed:
Enter username or HELP>
(Any name is acceptable as a user name.)
5
At the
Local>
prompt, enter
s u
ETR-CH06 Page 5 Wednesday, October 23, 1996 9:24 PM
