Xerox WorkCentre 4260 Series, System Administration Manual

Page: 166 / 210

15 Security
154 Xerox WorkCentre 4260 Series System Administration Guide
6. Click on the [SNMP] link.
7. Click on the [Enable] checkbox.
Edit SNMP settings
8. Click on the [Edit] button.
If prompted, enter the Administrator’s User ID [admin] and Password [1111] , and
click on [Login] .
9. Enter the [GET Community Name] and [SET Community Name] details under the
Community Names area.
NOTE: If you change the GET and/or SET Community Names, you must change all network
applications that are communicating via SNMP with this machine to use the new GET/SET
names.
10. Enter a name for the default [TRAP Community Name] . The default is SNMP_trap.
The Default TRAP community name is used to specify the default community name
for all traps generated by this machine. A trap is a notification of an event.
11. Click on the [Enable] checkbox to enable [Authentication Failure Generic Traps] .
When the [Authentication Failure Generic Traps] is enabled, the machine will
generate a trap for every SNMP request that is received by the machine which
contains an invalid community name.
12. Click on the [Apply] button to accept changes, [Cancel] to return the settings to their
previous values and return to the SNMP Properties screen, or [Undo] to return the
settings to their default values but remain in the Community Names screen.
Trap Destination Addresses
You can specify Trap Destination Addresses.
13. In the Trap Destination Addresses area click [Add IP Address] .
14. Enter the [IP Address] and [UDP Port Number] in the IP Trap Destination Address
area.
15. In the Traps area, enter the name in the [TRAP Community Name] box.
16. Select the Traps to be received. The Traps are:
• Printer Traps.
• Cold Start Generic Traps.
• Warm Start Generic Traps.
• Authentic Failure Generic Traps.
NOTE: When Authentication Failure Generic Trap is enabled, the machine will
generate a trap for every SNMP request that is received by the machine which
contains an invalid community name.
17. Click on the [Apply] button to accept the changes.
If prompted, enter the Administrator’s User ID [admin] and Password [1111] , and
click on [Login] .