11. Carefully remove the mis-fed media from the hot and sharp areas shown above.
12. Close the Exit Cover.
13. Hold the Inner Transport Handle while releasing the Inner Transport Lock, and gently
guide it back into the original position.
14. Return the green Inner Transport Handle to the lock position ensuring it latches
NOTE
If the Inner Transport Assembly is not locked firmly, the PF Indicator Light on
the Operator Panel will light along with a U-04 Open Error Code on the Status
Display.
15. Close both the Left and Right Side Doors.
16. Open the media drawer selected and rewind the media roll to the original position
which is slightly between the feed rolls. If too much media had advanced, it may
misfeed.
17. Close the Media Drawers.
18. If the leading edge is not sufficiently square, perform the automatic Initial Cut by
pressing the [Select] key to select the appropriate drawer, and then pressing [Cut]
key. Approximately 9.5” (240mm) media will be cut and fed from the printer.
19. Ensure the Stacker power is on.
NOTE
Roll 3 only: Rotate the Lower Feed Roller by hand until the lead edge is visible
in the center of the Viewing Hole.
Clearing Misfeeds in the Folder (J-21)
When the media is misfed in the optional Folder, J-21 is indicated. See the User Guide
of Folder and remove the misfed media.
9-25
Xerox
®
Wide Format 6622 Solution
™
User Guide
Problem Solving
Summary of Contents for Wide Format 6622
