Xerox Versant 180 Press, User Manual

Page: 127 / 166

Suggested solutions Problem
• You can sometimes minimize curl problems by flipping the paper
over in the tray. If excessive curl is still present, use a heavier
paper.
• To ensure continuous production, empty the output device
when the output approaches the maximum amount that the
device can hold; refer to the specifications for that output device
for output limit amount.
• An attempt to print on thicker paper or on paper stock that is
less sensitive to moisture.
Paper curl can be adjusted in the following ways:
• If the Interface Decurler Module or Interface Decurler Module
with ILS is attached, use the manual decurl buttons on the
module's control panel. Refer to the For information on these
devices, refer to the Optional Devices Guide for Xerox
®
Versant
®
180 Press.
• Refer to Custom Paper Settings Troubleshooting table, Paper
Curl.
• Also, use the “Adjust Paper Curl” feature; for more information,
refer to the System Administration Guide.
Unable to print with current
fuser assembly. Output pa-
• Replace the fuser assembly with one that supports the specific
paper width for the current print job. For more information,
refer to
Fuser Hints and Tips .
per width does not match
the installed fuser.
• Cancel the current print job and continue with the print job by
resubmitting from the print server.
Note
Recommend not overriding. This mismatch could prematurely
damage the fuser.
Message on UI will not
clear.
• If the fault is a paper jam, ensure that any paper is removed
from the area and that there are no hidden or small pieces of
paper left behind.
• Reboot the press by pressing the On/Off button located on top
of the press near the UI.
Check that Transparencies is selected as the paper type. The press
adjusts for different types of media; paper can tolerate more heat
than transparencies. Deformed transparencies.
Check paper curl and that the paper tray guides are locked into
position against the paper.
Note
Mixed media sizes may not stack well.
Output is not stacked cor-
rectly.
6-5 Xerox ® Versant ® 180 Press
User Guide
Troubleshooting