Xerox Versant 180 Press, User Manual

Page: 112 / 166

If dirt is difficult to remove, try gently wiping with a soft cloth moistened with a small
amount of neutral detergent.
3. Close the top cover of the document feeder until you hear it click into place.
4. Close the left cover of the document feeder until you hear it click into place.
Cleaning the Drum Drawer Area
When you are replacing a drum cartridge, and before inserting the new cartridge, perform
these steps to clean under the drum cartridge area:
1. With the Drum Cartridge Drawer open, look for dry ink/toner waste on the bottom
of the catch pan under the drum cartridges.
2. Use a clean cloth to wipe down the catch pan.
3. Continue following the instructions on how to insert the new cartridge.
Cleaning the ROS Windows
Unfused dry ink/toner collects on the 4 color ROS window areas located just above the
Drum Cartridge Drawer within the press. Contaminated ROS windows can cause a white
streak defect on your printed output.
Perform this procedure to clean the ROS window of the affected color whenever:
• You replace the drum cartridge
• A white streak (no image captured) shows in the same position on every print
Note
Use only the wand and cloth pad provided when performing this cleaning procedure.
Do not use any other cleaning device, liquid solutions, or cloths.
1. Open the Left Front Door of the press.
2. Locate the Cleaning Wand tool stored on the side panel of the open front door and
remove.
Make sure the pad at the tip of the wand is clean. Replace the pad after 4 uses. Several
pads are provided in the Nationalization Kit. To acquire additional pads, contact your
Service representative.
3. With the pad facing upward, insert the wand fully into the ROS color window opening
and then bring the wand fully out towards you. Complete this in/out action 3 or 4
times in each ROS window.
4. Replace the Cleaning Wand tool into the storage area on the side panel of the open
front door.
5. Close the Front Door of the press.
Xerox ® Versant ® 180 Press 5-4
User Guide
Maintenance