Xerox DocuPrint C55, Supplementary Manual

Page: 341 / 395

S Y S T E M M A I N T E N A N C E 18
Determining a Successful Upgrade
ESS
There will be an indication if your upgrade is successful. For an ESS
(Printer) upgrade you will receive a new start up page. The “Software
Version” on the start up page should reflect the software level of the
upgrade.
NIC
For the NIC upgrade you will receive a confirmation page if your upgrade
is successful. On the confirmation page will be the new software version
for the NIC. If the NIC upgrade fails for any reason you will receive an
error page explaining what failed (for example, if you send an Ethernet
flash to a Token Ring NIC, the error tells you it is the wrong firmware/card
combination).
After the Upgrade
After a successful Printer (ESS) upgrade all printer features will be set to
the factory defaults. You will need to reset key settings in the printer.
Some of these parameters include settings that allow you to print to the
printer. If printing over a network, these parameters must be reset before
you will be able to print. You will need the previously printed Settings
page and Diagnostics page.
After a successful NIC upgrade, power off and on the printer. Print a Print
Settings page and make sure the network settings are as you expect.
Resetting parameters should not be necessary for a NIC only upgrade.
After a successful ESS upgrade, using the directions in the section labeled
Check the following before the Upgrade, print out a new Print Settings
Page and Diagnostics page. Compare the original settings page with the
new one. Items that may be different include: Serial Number, Appletalk
Name, Timeout settings, Novell Settings (Primary Server, Print Server
Name, Tree and Context), TCP/IP Settings (IP Address, Subnet Mask,
Default Gateway). Identify the items that are different between the 2
settings pages. Use CentreWare DP or the Control Panel (in some cases
both) to restore settings. If you require assistance please contact your
Xerox Customer Support Center.