Xerox DocuPrint C55, Supplementary Manual

Page: 140 / 395

M A C I N T O S H 7
Step-by-Step Setup (AppleTalk)
Configuring EtherTalk/TokenTalk at the Control
Panel
The EtherTalk factory default settings are listed below:
•
<PHASE> = <2>
•
<ZONE> = *
•
<MODE> = <Auto Select>
If you do not need to change the default settings, proceed to the
section entitled Selecting the DocuPrint Printer from the Chooser.
To change the settings, follow these steps:
1. At the Control Panel, press the
On Line
button. Make sure that
the LED above the button is
OFF
and the Control Panel says
offline
.
2. Press
Menu
button. The
ON-LINE
message disappears and
TOP MENU
is displayed.
3. Press the
Next
button until
<COMMUNICATIONS>
is
displayed and then press
ENTER
.
4. Press the
Next
button until
<NETWORK SETUP>
is displayed
and then press
ENTER
.
5. Press
Next
button until
<ETHERTALK>
or
<TOKENTALK>
is displayed and then press
ENTER
.
6. Press the
Next
button until
<PHASE>
is displayed and then
press
ENTER
.
7. Press the
Next
button until your choice of (Phase) 1 or 2 is
displayed and then press
ENTER
.
8. Press
On Line
. Be sure that the light above it goes
ON
and the
message in the window is
ON LINE
.