DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
XEROX DOCUPRINT IPS MESSAGES GUIDE
3-17
F137
Excess belt holes detected.
The machine has detected too many holes on the photoreceptor belt.
Action
If trained to do so, replace the photoreceptor belt. Press the
[Continue] button. If the error persists, contact your service
representative.
F140
Dynamic Stray Check fault, unscheduled sheet is detected and
stopped at the stacker entry sensor.
Indicates that a "stray" sheet is detected and stopped at the stacker
entry sensor.
Action
Check the Duplex or Bypass Gate for binding and for a sticking
solenoid.
F142
Output tray elevator fault.
Three unsuccessful attempts were made to move the output tray
elevator down.
Action
Empty the output tray. Check for and remove any obstructions and
press the [Continue] button. If the problem persists, call your service
representative.
F143
Finisher front cover interlock open.
The front cover of the output module is not securely in place.
Action
Remove and discard any purged sheets, close the front cover and
press the [Continue] button. (Your service representative will have to
fasten the cover.)
F153
Too many sheets in duplex tray.
A multifeed error occurred causing too many sheets to remain in the
duplex tray. This prevented the set separator from activating the
empty tray switch when the required number of sheets was fed from
the duplex tray.
Action
Discard any unusable sheets and retry the operation. If the error
persists, contact your service representative.
F157
Output device input jam, late arrival to entry sensor/switch.
A jam occurred while paper was entering the output module.
Action
Follow the instructions that display to locate and clear the jam, or
clear the entire paper path. Close the stacker covers and press the
[Continue] button. If the error persists, contact your service
representative. (Refer to the
Xerox DocuPrint 4850/4890
or
92C IPS
Troubleshooting Guide
for the procedure.)
