Resource
168
XBLUE Networks
UAR
T T
yp
e
6.4
UART
Type
MBC - 4-24
This parameter is used to set the signaling protocol for the RS232 port on the Option
Board. Select between “SMDR” or “RMP”. When using RMP, SMDR will be disabled, likewise
when SMDR is enabled, RMP will be disabled.
Data Range: SMDR/RMP
Factory Setting: SMDR
Press
chg
to select
CID
Repeater
Modulation
MBC - 4-25
This parameter affects the coding method for which Caller ID data is detected on CO Lines.
The system is capable of detecting CID on CO Lines for incoming (ringing) call. The system
can detect either FSK or DTMF signaling for CID but cannot be set for both simultaneously.
Choose the method required for your application and set that value here. (Usually the
modulation method is “FSK”.)
Data Range: FSK/DTMF
Factory Setting: FSK
Press
chg
to select
Volume
Limit
MBC - 4-26
This parameter is used to determine allowable volume (gain) adjustment settings for the
function modes: “Page Level”, “Speaker Limit”, and “Handset Limit”. This can be used to
control overall office noise levels and to set maximum allowable settings for the benefit of
the users.
•
Data Range:
•
Page Level: 1 ~ 8
•
Speaker Limit: 1 ~ 8
•
Handset Limit: 1 ~ 8
Summary of Contents for 45P
