Xantrex XKW 12-150, Operating Manual

Page: 32 / 90

Installation
Returning Power Supplies to the Manufacturer
30
Operating Manual for XKW 3kW Series Power Supply
Packaging for
Shipping or
Storage
Follow these instructions to prepare the unit for shipping or storage.
1. When returning the unit or sending it to the service center, attach a tag to the unit
stating its model number (available from the front panel label) and its serial
number (available from the rear panel label). Give the date of purchase and an
invoice number, if you have it, as well as a brief description of the problem.
2. For storage or shipping, repack the power supply in its original container. If the
original container is not available, seal the unit in a plastic bag and then pack it
in a 200 lb. (90 kg) test, corrugated cardboard carton large enough to allow 2
inches (5 cm) of cushioning material to surround the unit. Use a material such as
foam slabs or chips.
3. Label the carton as shown in Figure 2.1 .
4. If shipping, mark the address of the service center and your return address on the
carton.
5. If storing, stack no more than eight cartons high. Check the storage temperature
range and storage altitude specification in “Environmental Specification” on
page 24.
Figure 2.1 Shipping or Storage Carton Label
POWER SUPPLY
Model Number: _______________________
Serial Number: _______________________
FRAGILE — ELECTRONIC EQUIPMENT
TM-25OP-01XN.book Page 30 Monday, April 5, 2004 8:58 AM