WIM-PD-002_B
Page
15
of
38
5.0
Disassembly
Warning
Follow safety guidelines utilizing lockout tag out procedures before and during all installation and
maintenance procedures.
Warning
Ensure that proper rated lifting devices & procedures are followed when installing, working, or maintaining
unit. Failure to do so may result in equipment damage, personal injury and even death.
5.1
Remove PTO from Pump Drive
5.1.1
Remove drive shaft or belts from PTO output shaft.
5.1.2
Remove the mounting bolts attaching the PTO to the flywheel housing, remove those
located near the top last. The PTO should separate from the flywheel housing. If the
PTO does not separate, gently pry the flanges apart until the housing is removed from
the engine flywheel housing pilot diameter.
5.2
Remove all Auxiliary Attachments.
5.2.1
Disconnect all hoses from auxiliary pumps/motors.
5.2.2
Remove the mounting bolts from the auxiliary unit to the pump pad, remove those
located near the top last.
5.3
Remove Pump Drive for Disassembly
5.3.1
After all auxiliary attachments have been removed and the PTO has been removed
proceed with the following steps.
5.3.2
Disconnect and remove all hardware from pump drive and engine.
5.3.3
Drain all oil from pump drive by removing drain plug from bottom of unit.
5.3.4
If unit has not been moved to secure clean area do so now.
Summary of Contents for WPD-02
