WIM-PD-002_B
Page
36
of
38
12.0
Trouble Shooting Guide
Problem
Possible Cause
Remedy
Fluid Leaks
Output main seal damaged
Inspect and replace seal as needed
Input main seal damaged
Foaming in Pump Drive Case
Oil level too high
Inspect oil level and drain as needed
Incorrect oil type
Verify approved oil is used
Smoking from Vent
Oil level low
Inspect oil level and drain as needed
Incorrect oil type
Verify approved oil is used
Excessive loading on auxiliary
pads
Contact WPT Applications
Engineering for support
Pump Drive Case is Hot (200
F or higher)
Oil level too high
Inspect oil level and drain as needed
Oil level too low
Inspect oil level and drain as needed
Incorrect oil type
Verify approved oil is used
Excessive loading on
auxiliary pads
Contact WPT Applications Engineering for
support
Excessive Vibrations
Worn engine bearings
Inspect endplay and runout on engine flywheel,
replace or repair as needed
Worn pump drive bearings
Inspect main and auxiliary bearings,
replace as needed
Improper alignment
Check alignment and adjust as
necessary
Improper input coupling
Contact WPT Applications
Engineering for support
Summary of Contents for WPD-02
