WIM-PD-002_B
Page
5
of
38
2.1
Product Description
The PPD is a multi-pump drive that attaches to the engine similar to a power-take off and
distributes the power to one or two heads. Each head has the possibility to mount two pumps.
With a flange adapter, a Type D, 4-hole mount is available. On the engine side flange, there are
Type B, 2-hole, and Type C, 2- and 4-hole mounting pads.
The input is connected to the flywheel of the engine through an elastic coupling which is
connected to the main shaft and consequently to the gears. On the output shaft a flywheel is
available. Thus, any equipment with SAE sizes 0 through 3 meeting J617 and SAE 11.5
”
through
18”
meeting J620 can be installed.
When ordering replacement parts, use the part numbers from the Bill of Material and drawing
supplied with the brake. The most current documents may be obtained by contacting WPT or
an authorized distributor. When ordering parts, provide the assembly number and serial number
for the unit found on the brass tag affixed to the front of the brake. See the example shown in
the figure immediately below.
“F” style shown with circulation pump and heat
exchanger Engine side
“B” style shown with head
extension.
PTO side
Throughout this manual the terminology shown above may be used to refer to one side or the other.
Input side shall be known as “Z” side and the output side shall be known as “Y” side.
Summary of Contents for WPD-02
