WIM-PD-002_B
Page
16
of
38
5.4
Disassembly Main Shaft
5.4.1
Remove “Y” side output flywheel by removing SHCS from center
.
5.4.2
Remove hardware holding flange adapter.
5.4.3
Remove hardware to remove bearing carrier.
5.4.4
Remove output main bearing.
5.4.5
On “Z” side remove
hardware to remove shaft retainer.
5.4.6
After shaft retainer is removed coupling maybe removed.
5.4.7
Remove hardware to remove input housing.
5.4.8
The main shaft may be removed from the output side.
5.4.9
You must separate the main sprocket from input bearing before either may be
removed from housing.
5.5
Disassembly Intermediate Shaft Driving
5.5.1
Remove “Y” side output
intermediate hardware to remove cover.
5.5.2
With input housing removed remove spacer.
5.5.3
Once spacer is removed you may remove bearing.
5.5.4
With bearing removed you may pull intermediate shaft out freeing up output bearing.
5.6
Disassembly Intermediate Shaft Driven
5.6.1
From “Z” input side remove retaining hardware running through shaft
.
5.6.2
Pull shaft out from housing on input side.
5.6.3
With head or head cover removed you may remove sprocket and bearing through head
opening to disassembly further.
5.6.4
Remove hardware holding retainer plate from each side if sprocket.
Summary of Contents for WPD-02
