WIM-PD-002_B
Page
9
of
38
4.1.3
Check flywheel face run out.
Mount the indicator base on the flywheel housing and position the dial indicator tip so its
movement is perpendicular to the face of the flywheel. Position the indicator tip near the
drive ring mounting bolt circle diameter. Rotate the flywheel 360 degrees while holding
pressure against the crankshaft thrust bearing. The total indicator reading should not exceed:
11” Clutch: 0.007 inches (0.18 mm)
14” Clutch
: 0.009 inches (0.23 mm)
18” Clutch: 0.011 inches (0.28 mm)
4.1.4
Check flywheel pilot bore run out.
Mount the indicator base on the flywheel housing and position the dial indicator tip so its
movement is perpendicular to the face of the pilot ring inner diameter on the flywheel.
Rotate the flywheel 360 degrees. The total indicator reading should not exceed:
All Flywheel Sizes: 0.005 inches (0.13 mm)
CAUTION
NOTE: Consult PTO manual when installing PTO to pump drive.
Summary of Contents for WPD-02
