Woodway 4Front, Service Manual

Page: 56 / 97

56 05/2016 – SM-MT-EN-02
1. Unplug treadmill from the power supply. Ensure it cannot be turned back on.
2. Remove silver plates on the old contact heart rate grips by prying up the edge of
the plate with the small standard screwdriver (Pos. 1).
3. Carefully, remove the wire attached to each plate by gripping the connector with
the pliers (Pos. 5). Never pull directly on the wire.
4. Using the Phillips head screwdriver, remove the 2 gold screws located in the center
of the plastic grips. Remove the plastic grips (Pos. 2, 3).
1. Remove the contact plates from the new grips by pushing a screwdriver through
one of the holes on the inside of the grip.
2. Install the new plastic grips using the new hardware (included). The grips only fit
together in one orientation. If it does not look like a proper fit, turn one of them
around and try to fit them together once more. Make sure the wires are coming
through the holes in the plastic grips where they were prior to disassembly
(Pos. 2, 3, 4).
3. Attach the wire to the silver plate by first removing the white plastic coating on the
cover of the silver plate. Attach the wire to the post (Pos. 5).
4. Remove the paper backing from the new plastic grip and press the silver plate into
the grip. This should fit snugly and not be raised; if not all edges are flush, pull up
with the screwdriver and re-install.
Note: Left back (blue), left front (orange), right back (brown), right front (yellow)
Removal
Installation