Woodway 4Front, Service Manual

Page: 78 / 97

78 05/2016 – SM-MT-EN-02
9 Cleaning and Maintenance
9.1 General
Periodic cleaning and inspection of your WOODWAY treadmill will help to lengthen its
life while keeping it looking like new. Preventative maintenance makes it easier to locate
potential issues that might not otherwise be noted.
See the supplied User’s Manual for a guideline of the recommended cleaning and
maintenance intervals.
WARNING
Danger of Injury due to Lack of Qualifications!
If maintenance or repairs are not carried out by professionally qualified person-
nel, serious injury and material damage may occur.
►
Maintenance and repair work may only be performed by qualified personnel.
►
It is the sole responsibility of the representative to assign qualified personnel
for maintenance and repair work.
►
Clean and examine the machine regularly for damage and/or wear, paying
special attention to areas susceptible to wear.
►
In case of doubt or questions, always contact WOODWAY Customer Service
or your dealer.
►
The manufacturer is not liable for personal injury and material damage
caused by a lack of qualifications!
9.2 Lubrication
9.2.1 Bearings
Almost all bearings in the treadmill have been lubricated by the manufacturer and need
not be greased. The 4 bearings at the front and rear axles must be lubricated once a
year with one stroke of the grease gun.
 Remove the side panels when lubricating bearings.
 One pump of grease can be inserted into Zerk fittings on bearings (need a grease
gun with a flex bit).
 If necessary, tighten bolts that secure bearings to the frame.
 Tighten set screws on bearing collars. Use red Loctite to ensure the set screws stay
tight.

All set screw torque settings must be at 68 in-lbs.
 The ELG torque setting for the set screws must be at 273 in-lbs.