Woodway 4Front, Service Manual

Page: 53 / 97

05/2016 – SM-MT-EN-02 53
6.8 Side Switch Assembly Replacement
Save all removed hardware for installation of replacement parts.
Fig. 53 Side switch assembly replacement
1. Overlay
2. Side switch PCB
3. Plastic housing
4. PCB screws
5. Handrail
Standard screwdriver
Phillips head screwdriver
1. Unplug the treadmill from the power source. Ensure it
cannot be turned back on.
2. Using a standard screwdriver, remove PCB overlay (Pos. 1) from the side switch as-
sembly by carefully prying up the corner of the overlay. Once a corner is lifted, the
overlay should peel off easily.
3. Remove the three #8 (32 x ½”) Phillips flat head machine screws that hold the side
switch PCB down (Pos. 2, 4).
4. Lift the PCB and housing to expose the wire that it plugged into the PCB (Pos. 2, 3).
5. Carefully, remove the plug from the PCB.
1. Place the PCB in the plastic housing, taking care to
align the PCB plug with the cutout on the plastic housing (Pos. 2, 3).
2. Plug in the cable that runs from the display to the side switch assembly.
3. Attach the PCB and housing to the handrail using the three #8 (32 x ½”) Phillips
flat head machine screws (Pos. 4).
Tools Needed
Removal
Installation