Woodway 4Front, Service Manual

Page: 73 / 97

05/2016 – SM-MT-EN-02 73
To adjust belt movement through the treadmill’s color LCD display, perform the follow-
ing:
1.
Turn the treadmill display board ON.
2. Press 9-2-2-ENTER (in that order). The Options Menu will appear on the display
screen.
3. Press 3-9-2-1-8 (in that order). This will give you access to the lower half of the
screen.
4. Use either FAST/SLOW speed key to stop the belt movement.
5. Once the belt is stopped, press the OFF button on the display to save the changes
and exit Calibration Mode.
To adjust belt movement through the treadmill’s LED display, perform the following:
1.
Turn OFF the treadmill at the main switch (at base of treadmill by power cord).
2. Hold down the INCLINE UP button and flip the main power switch to ON.
3. Press the INCLINE UP button until the display reads “bCrP”.
4. Use either FAST/SLOW key to stop the belt movement.
5. Once the belt is stopped, press the PAUSE key to save the changes and then turn
the treadmill OFF at the main power switch to exit Calibration Mode.
8 Troubleshooting
If you have problems with your treadmill, please consider the answers to the following
questions before calling WOODWAY Customer Service.
 What are the make, model, and serial number?
 What happened before the problem occurred?
 Did the problem occur suddenly or slowly over time?
 Was the treadmill in use when the problem occurred?
 Was the running surface ENGAGED or was it in DYNAMIC MODE?
 Explain all other information that you consider relevant.
8.1 No Power
If the treadmill will not power up and the fan does not come on when the main power
switch is ON, there is an issue inside the AC bracket. Perform the following:
 Check the main fuse.
 Check the fuse continuity by pulling the fuse from the fuse-holder. Set a voltmeter
to Ohms and attach each lead to each end of the fuse.
- If the fuse is good, the voltmeter should read 0 Ohms.
- If the fuse is bad, it needs to be replaced.
 Ensure there is 120 VAC going into the line side of the line filter.
-
If voltage is bad, the issue is with the fuse holder or main power switch.
- If voltage is good, check the load side of the line filter to make sure there is
120 VAC coming out.
- If there is no voltage at the load side, the line filter is bad.
Standard LED
Desmo (05+), ELG
Mercury, Path,
Desmo (00 – 04)
Personal Trainer LCD
Desmo (05+), ELG
Mercury, Path,
Desmo (00 – 04)