Woodway 4Front, Service Manual

Page: 48 / 97

48 05/2016 – SM-MT-EN-02
6.4 Side Cover Replacement
Fig. 49 Side cover replacement
1. Side cover
2. Side cover screw
3. Boot
4. Boot screw
Standard screwdriver
Phillips head screwdriver
Perform the following steps in order to properly remove the side cover:
1. Remove the trim plate/boot screws using either the standard/Phillips head screw-
driver and slide the trim plate/boot up the handrail slightly (Pos. 3, 4).
2. Using the Phillips head screwdriver, remove the 2 Phillips flat stainless screws locat-
ed on both ends of the side cover (Pos. 2).
3. Remove the side cover (Pos. 1).
Perform the following steps in order to properly reinstall the side cover:
1. Place the side covers back on the frame. Make sure the tabs on the bottom of the
covers are placed under the frame.
2. Install the 2 side cover screws and decorative washers. Do not tighten them com-
pletely until they are all in place.
3. Slide the trim plate/boot back down the handrail and install the 4 screws in the
frame, making sure to keep them loose until they are all in place.
4. Tighten all the screws. Tighten the boot screws just until they are touching the rub-
ber. Do not over tighten the screws.
Tools Needed
Removal
Installation