Woodway 4Front, Service Manual

Page: 25 / 97

05/2016 – SM-MT-EN-02 25
4.2.3 Encoder Connector (P1)
+5 VDC, red
Common, black
Output U, violet
Output V, white/brown
Output W, white/orange
+5 VDC, (not used)
Output A, brown
Output B, blue
Common, (not used)
4.2.4 Control Connector (P2)
(Not used)
Common, brown
Common, black
Analog speed signal input, +/- 10 VDC, + clockwise rotation, 0 VDC = 0 RPM, red
Assigned to common, black wire/frame ground, (not used)
Assigned to fault output, +5 = OK, 0 VDC = FAULT, (not used)
+5 VDC speed pulse out, ~64 Hz/RPM, blue
Assigned to current output, 1 VDC = 3.33 Amps, (not used)
Inhibit, open to run, disable/reset trips when pulled low, white
Common, green
4.2.5 Calibration Buttons
To change a setting, hold down the appropriate calibration button for ½ second. The in-
terface board will not recognize quick pulses of the buttons.
To save/store settings, pull the emergency stop magnet off the display. This disables
the drive and records the settings into flash memory. If the treadmill is powered down
before the settings are saved, they will be lost.
[+] 0 MPH belt movement adjustment (forward increase, backward decrease)
[-] 0 MPH belt movement adjustment (forward increase, backward decrease)
[+] Speed calibration
[-] Speed calibration
[+] Belt stiffness, DO NOT TOUCH!
[-] Belt stiffness, DO NOT TOUCH!
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
S1
S2
S3
S4
S5
S6