several times to ensure smooth unrestricted
travel prior to reassembly.
20. Replace the four (4) screws securing vent
assembly to rear of fryer. NOTE: Vent
tube must protrude through vent assembly
at least 1/2" (See Figure 34).
21. Connect the two (2) solenoid wires to
harness wires.
22. Place new O-ring over vent tube and slide
back against vent assembly.
CAUTION:
Prior to applying final torque to
screws in Step 23, verify solenoid
wires are not pinched between nut
plate and vent assembly. This could
create a shorted circuit causing potential
equipment damage and/or personal injury.
23. Place vent block on vent tube, line up nut plate behind vent assembly and replace the four
(4) screws securing block to vent tube and vent assembly.
24. Drop vent ball (if applicable) down through waffle onto vent block.
25. Place weight down in weight lifter.
26. Place vent back onto vent assembly.
27. Replace the seven (7) screws securing back panel and Danger Label panel to rear of fryer.
28. Place muffler onto fryer and place unit back into service.
REPLACE DRAIN VALVE
(ITEM NO. 13)
Tools:
Nut Driver - 5/16”; Open End Wrench - 7/l6”; Wrench - l-3/16”.
Procedure:
1.
DANGER:
Turn off electrical power, disconnect electrical power supply, drain shorten-
2. Remove nut securing drain valve extension handle to drain valve and save for reuse
3. Remove the two (2) screws securing locking plate to drain valve bracket and save
for reuse.
WINSTON
55
LIT.6710/REV.0/9-91
FIG. 34
ing and allow to cool. If unit is hardwired,
CIRCUIT BREAKER MUST BE OFF.
19. Manually depress and release weight lifter
