REPLACE HEATER HOLDER
(ITEM NO. 31)
Tools:
Nut driver 7/16”; Rubber Mallet.
Procedure:
1.
DANGER:
Turn off electrical power and disconnect electrical power supply; drain
shortening and allow to cool. If unit is hardwired,
CIRCUIT BREAKER MUST BE
OFF.
2. Remove lid from fryer.
3. Remove the two (2) nuts securing heater holder to cooking vessel wall.
4. Utilizing care not to damage heaters, remove heater holder.
5. Replace the two (2) nuts securing new heater holder to cooking vessel wall.
6. Utilizing care not to damage heaters, gently tap heaters with rubber mallet securing them
in slots in heater holder.
7. Replace lid on fryer and place unit back into service.
REPLACE FUSE
(ITEM NO. 53)
Tools:
Phillips Screwdriver #2.
Procedure:
1.
DANGER:
Turn off electrical power and disconnect electrical power supply. If unit is
hardwired,
CIRCUIT BREAKER MUST BE OFF.
2. Remove the two screws securing eyebrow to relay panel and save for reuse.
CAUTION:
Utilize care in preventing escutcheon from falling forward when removing
screws in Step 3.
3. Remove the four (4) screws securing escutcheon to relay panel and save for reuse. Lower
escutcheon slowly until secure open position.
4. Unscrew fuse cap from fuseholder.
5. Remove defective fuse from fuseholder.
6. Insert new fuse into fuseholder.
7. Screw fuse cap back onto fuseholder.
WINSTON
37
LIT.6710/REV.0/9-91
