REPLACE LID VALVE ASSEMBLY
1.
Procedure:
DANGER:
Turn off electrical power and disconnect electrical power supply. If unit is
hardwired,
CIRCUlT BREAKER MUST BE OFF.
Tools :
Slotted Screwdriver 1/8".
2. Move or rotate handle bar to open position. Lift lid above front block and remove from
fryer. Depress lid lock and remove handle bar from lid. Save handle bar for reuse
3. Remove lid lock from lid assembly end save for reuse.
5. Remove lid valve retainer. Note that lid valve spring has closed coil on one end and open
coil on the other. The open end goes toward the lid. Save spring and retainer for reuse.
4. Lift Lid and hold valve body with one hand. Grasp the lid valve retainer with the other
hand and twist counterclockwise to loosen.
6.
7.
8.
Remove valve body and lower lid.
Lift lid and install new valve body on lid. Make sure the groove for the lid lock is toward
the front. Lean the lid toward the back of the fryer.
Holding top part of valve with one hand, install spring, (open coil toward the lid). Using
other hand turning clockwise, carefully screw retainer into valve body. Using only hand
9.
pressure, completely tighten retainer to valve body.
Lower lid and replace lid lock.
10. Depress lid lock, replace handle bar and place unit back into service
2. Move or rotate handlebar to open position. Lift lid above front block and rcmovo from
fryer Depress Lid lock and remove handle bar from lid.
3. Install new handle bar in lid assembly and place unit back into service.
REPLACE HANDLE BAR
Tools :
N/A
CAM LOCK AND PRESSURE LOCK (ITEM NO. 2)
(ITEM NO. 3)
WINSTON
36
LIT.6710/REV.0/9-91
1.
Procedure:
DANGER:
Turn off electrical power and disconnect electrical power supply. If unit is
hardwired
CIRCUlT BREAKER MUST BE OFF.
