6. Replace the four (4) screws securing new relay to panel.
7. Observing wire location markings, connect wires to proper relay terminals.
8. Replace the four (4) screws securing escutcheon to relay panel.
9. Replace the two (2) screws securing eyebrow to relay panel and place unit back into service.
REPLACE TRANSFORMER
(ITEM NO. 48)
Tools:
Phillips Screwdriver #2; Nut Driver -3/8”; Wire Cutters.
Procedures:
1.
DANGER:
Turn off electrical power and disconnect electrical power supply. If unit is
hardwired,
CIRCUIT BREAKER MUST BE OFF.
2. Remove the two (2) screws securing eyebrow to relay panel and save for reuse.
CAUTION:
Utilize care in preventing escutcheon from falling forward when removing
screws in step 3.
3. Remove the four (4) screws securing escutcheon to relay panel and save for reuse. Lower
escutcheon slowly until secure in open position.
4. Remove wire tie securing transformer wires to main harness.
5. Disconnect the two (2) transformer plugs from harness plugs.
6.
Remove
the two (2) nuts securing transformer to escutcheon and save for reuse.
7. Replace the two (2) nuts securing new transformer to escutcheon.
8. Insert the two (2) transformer plugs into harness plugs.
9. Replace the four (4) screws securing escutcheon to relay panel.
10. Replace the two (2) screws securing eyebrow to relay panel and place unit back into service.
REPLACE FUSE HOLDER
(ITEM NO. 52)
Tools:
Phillips Screwdriver #2; Slotted Screwdriver; Wrench-5/16”
Procedure:
1.
DANGER:
Turn off electrical power and disconnect electrical power supply. If unit is
hardwired,
CIRCUIT BREAKER MUST BE OFF.
2. Remove the two (2) screws securing eyebrow to relay panel and save for reuse.
WINSTON
27
LIT.6710/REV.0/9-91
