17. Replace the four (4) screws securing
vent assembly to rear of fryer.
NOTE:
Vent tube must protrude
through vent assembly at least l/2"
(See Figure 16).
18. Connect the two (2) solenoid wires
to harness wires.
19. Place O-ring over vent tube and
slide back against vent assembly.
CAUTION:
Prior to applying final torque
solenoid wires are not pinched
between nut plate and vent
assembly. This could create
a shorted circuit causing potential
equipment damage and/or personal
injury.
20. Place vent block on vent tube, line up nut plate behind vent assembly and replace the four
(4) screws securing block onto vent tube and vent assembly.
21. Drop vent ball (if applicable) down through waffle onto vent block.
22. Place weight down in weight lifter.
23. Place vent back onto vent assembly.
24. Replace the seven (7) screws securing back panel and Danger Label panel to rear of fryer.
25. Place muffler onto vent back and place unit back into service.
REPLACE COTTER PIN
(ITEM NO. 60)
Tools:
Phillips Screwdriver #2; Needle Nose Pliers.
1.
DANGER:
Turn off electrical power and disconnect electrical power supply. If unit is
hardwired,
CIRCUIT BREAKER MUST BE OFF.
CAUTION:
Utilize care when removing muffler in Stop 3. Muffler may contain very
hot water.
2. Remove muffler and place in sink.
to screws in Step 20, verify
FIG. 16
Procedure:
WINSTON
42
LIT.6710/REV.0/9-91
