PAGE 91 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
f. Release the support bracket clamp and insert the estimated number of shims between the
support bracket clamp and the support bracket weldment (Figure 5-9). Do not pull out on
the support bracket clamp. If a shim does not easily fit between the support bracket clamp
and support bracket weldment, that shim is not necessary, and should not be used. Any
unused shims should be inserted between the support bracket clamp and the washer
plate. The shims should be inserted so that the bottom of the shims hangs down below the
bottom of the support bracket clamp.
Figure 5-9 Shims Inserted (Shown with Two Shims Used and One Spare)
g. Loosely secure the left side of the support bracket clamp to the support bracket weldment
with the remaining hardware. Align from outside in as follows:
Figure 5-10 Hardware Left Side
Support Bracket Weldment
Support Bracket
Clamp Flange
Washer Plate
One Spare Shim
Two Shims Used
i. ⅜-16 x 2.00 Cap Screw
ii. Flat Washer
iii. Washer Plate
iv. Support Bracket Clamp
v. Support Bracket Weldment
vi. Flat Washer (Hidden)
vii. Lock Washer (Hidden)
viii. Hex Nut
Summary of Contents for 10-60 HDL
Page 2: ......
