PAGE 90 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
d. The washer plate should be aligned so that its outside edge is flush with the outside edge
of the support bracket clamp (Figure 5-7). If the outside edge sticks out beyond the edge of
the support bracket clamp (Figure 5-7), it is installed backwards and needs flipped.
Figure 5-7 Hardware Positioning and Alignment
e. Press with your hand against the left support bracket clamp flange and push it towards the
support bracket weldment (Figure 5-8). Looking at the gap between the support bracket
weldment and the support bracket clamp, estimate how many of the shims can fit in the
gap while allowing the external support bracket to snugly secured to the mast, but without
bending the support bracket clamp.
Figure 5-8 Press the Support Bracket Clamp Flange Towards the Bracket Weldment
Hardware positioned on the
left side of the support bracket
Correct Washer Plate Alignment
Incorrect Washer Plate
Alignment
Washer Plate
Washer Plate
Beyond
Edge
Support Bracket Weldment
Gap
Support Bracket Clamp Flange
Summary of Contents for 10-60 HDL
Page 2: ......
