PAGE 104 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
5.7.2.7
Complete Installation of the Internal Mounting Kit
This section describes completing the installation of the Internal Mounting Kit as follows:
• Non-Rotatable Heavy Duty Masts
• Non-Rotatable Super Heavy Duty and Ultra Heavy Duty Masts
• Rotatable Heavy Duty Masts
• Rotatable Super Heavy Duty Masts
• Turning Handles
The exact installation procedures will vary depending on the configuration of the mast system.
Follow the appropriate installation instructions for your configuration.
Non-Rotatable Heavy Duty Masts
To complete installation, slide the weather bonnet, with the o-ring in the notch, down the mast
and over the roof flange. If the weather bonnet is difficult to maneuver, put soapy water on the
mast to allow them to slide more freely.
Non-Rotatable Super Heavy Duty and Ultra Heavy Duty Masts
To complete installation:
1. Remove the hardware securing the roof ring. Ensure the ceiling plate and gasket underneath
the roof do not fall.
2. Slide the retaining ring and o-ring down the mast.
3. Press the o-ring into the notch around the roof ring.
4. Position the retaining ring into place and ensure all the holes of the internal mounting kit align
with the holes in the roof.
Summary of Contents for 10-60 HDL
Page 2: ......
