PAGE 99 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
Figure 5-16 Ultra Heavy Duty Internal Mounting Kit (P/N: 5476101)
4. If necessary, use washers or short spacers made of ¼ inch (6.35 mm) pipe to level out any
irregularities that exist in the roof.
5. Apply a bead of silicone sealant to both sides of one gasket.
6. For Heavy Duty Masts:
a. Line up the holes of the roof, the gasket with silicone sealant applied, and the roof flange
(Figure 5-14). Ensure the gasket is between the roof and roof flange.
b. Replace any roof liner or ceiling panel.
c. Fit the other gasket (Figure 5-14) against the inside of the roof. This gasket does not need
sealant. It will be held in place by the ceiling plate. Fit the ceiling plate in place and ensure
all holes align.
Top of Mast
Bottom of Mast
Roof
O-Ring
Bearing Strip
Gaskets
Ceiling Plate
Retaining Ring
Roof
Ring
Summary of Contents for 10-60 HDL
Page 2: ......
