PAGE 100 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
d. Fasten this assembly (Figure 5-17) together using:
i. ¼ Inch (M6) Bolts
ii. ¼ Inch (M6) Lock Washers
iii. ¼ Inch (M6) Nuts
Figure 5-17 Fasten Assembly Together
The bolts should be sized to length to account for all components. The mounting hardware
must include proper means to resist vibration loosening such as thread-locking compound or
locking hardware. Torque all hardware as appropriate for its size and grade.
Note that the weather bonnet and o-ring are not yet installed (Figure 5-14).
e. Clean off any silicone sealant that may have squeezed out the hole cut for the mast.
f. Slide the weather bonnet and o-ring over the bottom of the base tube and up the mast past
the drain hole towards the collar. If they are difficult to maneuver, put soapy water on the
mast to allow them to slide more freely. Ensure the weather bonnet is oriented correctly,
and the o-ring is in the notch in the weather bonnet (Figure 5-14).
g. Temporarily secure the weather bonnet and o-ring in place so they cannot slide down the
mast during transportation.
h. Go to Section 5.7.2.3.
Summary of Contents for 10-60 HDL
Page 2: ......
