Configuration of gateways with samosPLAN
6
Wieland Electric GmbH | BA000970 | 07/2019 [9855]
45
Illustration 7: Configuration dialog in the “Properties” docking window
Function and basic settings
81134347
Routing
81142283
The process diagram, transferred to the network from the samosPRO gateway, comprises the opera-
ting data (e.g. logic results, state of inputs and outputs) and the diagnostic data (e.g. module status,
CRCs). This data have been arranged in 4 data sets.
Table 22: Content of data sets 1–4
Data set
Content
Size
Configurable
1
Process data
50 bytes
Yes
2
CRCs
32 bytes
No
3
State and diagnosis
60 bytes
No
4
Reserved
60 bytes
No
The process data in Data Set 1 may consist of up to 50 bytes, irrespective of the network protocol
used. These 50 bytes have been divided into one or several data blocks, depending on the network
protocol. Detailed information about the modularization of the data sent to the network may be
found in the section on the relevant gateway and in the following table:
process data transmitted in the network" [ch. 5.2.2, p. 46]
The content of data set 1 has been pre-configured with the addition of a gateway module or a gate-
way function, but can be freely configured with a granularity of 1 byte (see
Configuring the gateway output values (tab 1) [ch. 5.3, p. 47]
The diagnostic data in data sets 2-4 depends on the network protocol used and is described in the
chapter on the relevant gateway.
Basic settings for the process data
81160331
After the addition of the gateway, the process data is pre-configured. Depending on the gateway
used, this data is divided into several data blocks.
5.2
5.2.1
5.2.2
